SML

9.5mm Tie-bolt and bearing
9.5mm tie-bolt and bearing for 3-point punches up to 26mm diameter and for Bulldog punches up to 18.6mm diameter

19mm Tie-bolt and bearing
For 3-point punches from 27mm to 60mm diameter and for Bulldog punches from 28.3mm diameter and above

11mm Tie-bolt for 2-point (Bulldog) punches
11mm tie-bolt and bearing for 2-point (Bulldog) punches between 19.0mm and 25.0mm diameter

Special tie-bolt and bearing for square punches
For ‘Emka or Dzus’ punches (20.1 x 22.5mm)

Combined hand pump and cylinder
In carrying case with basic accessories

Hand pump and hydraulic cylinder
Hand pump with 1 metre flexible hose and hydraulic cylinder
In plastic carrying case with basic accessories

Foot pump with hydraulic cylinder
Foot pump with 2 metre flexible hose and hydraulic cylinder
With basic accessories but without carrying case

Foot pump and hydraulic cylinder in carrying case

Hole punches: 3 point – For mild steel and thinner stainless steel
Hole punches: 2 Point – For stainless steel
Hole punches: Square, rectangular & shapes

DIN Rail machine for cutting and punching
This is a heavy duty machine for use in a busy panel shop. It will give many years of service.
Includes a 1 metre measuring rail with adjustable end stop

DIN Rail machine for cutting
This economical machine is ideal for cutting DIN rail with pre-punched slots
Includes a 1 metre measuring rail with adjustable end stop

Electric pumps with foot controls
Electric pumps with hand controls
Hand pump
Foot pump

Copper cutting
Cutting machine for copper bar up to 125 x 10mm
Cutting machine for copper bar up to 200 x 20mm

Copper bending
Hydraulic operation 150 x 10mm
Hydraulic operation 200 x 15mm

Electronic angle control
Automatic stopping by cam and limit-switch
Manual bender 70 x 7.5mm
Manual bender 100 x 10mm

Copper punching
Punching machine 65mm throat
Punching machine 100mm throat